SPRAYON PRODUCTS -- 208 CUTTING OIL -- 9150-00-450-6938
===================== Product Identification ===================== Product ID:208 CUTTING OIL MSDS Date:01/14/1986 FSC:9150 NIIN:00-450-6938 === Responsible Party === Company Name:SPRAYON PRODUCTS Address:26300 FARGO AVE City:BEDFORD HEIGHTS State:OH ZIP:44146-1310 Country:US Info Phone Num:214-292-7400 Emergency Phone Num:216-292-7400 CAGE:09800 === Contractor Identification === Company Name:SHERWIN-WILLIAMS DIVERSIFIED BRANDS, INC. Address:26300 FARGO AVENUE Box:City:BEDFORD HEIGHTS State:OH ZIP:44146 Country:US Phone:216-292-7400 OR 216-595-8634 CAGE:09800 ============= Composition/Information on Ingredients ============= Ingred Name:CUTTING FLUID Fraction by Wt: 90.0% Other REC Limits:5MG/CUM AS OIL MIST Ingred Name:ISOBUTANE (PROPELLANT) CAS:75-28-5 RTECS #:TZ4300000 Fraction by Wt: 5.0% OSHA PEL:1000 PPM ACGIH TLV:1000 PPM Ingred Name:PROPANE CAS:74-98-6 RTECS #:TX2275000 Fraction by Wt: 5.0% OSHA PEL:1000 PPM ACGIH TLV:ASPHYXIANT; 9192 ===================== Hazards Identification ===================== Health Hazards Acute and Chronic:ACUTE:IRRITANT TO EYES,SKIN AND RESPIRATORY TRACT;DIZZINESS OR NAUSEA. CHRONIC:BRAIN OR CNS DAMAGE ON PROLONGED OR REPEATED CONTACT OR EXPOSURE. Effects of Overexposure:EYES/SKIN:IRRITANT;INHAL:ANESTHETIC,IRRITNT TO RESP.TRACT;HEADACHE,NAUSEA;INGEST:HARMFUL OR FATAL Medical Cond Aggravated by Exposure:NO DATA AVAILABLE ======================= First Aid Measures ======================= First Aid:INHALE:REMOVE TO FRESH AIR, GIVE CPR/O*2 IF NEED;EYES/SKIN:FLUSH W LG AMTS H*2O FOR 15 MIN;INGEST:RINSE MOUTH; GET MEDICAL ATTENTION FOR EYES, BREATHING DIFFICULTY, OR OTHER SYMPTOMS OF OVEREXPOSURE. ===================== Fire Fighting Measures ===================== Flash Point:N/R,PROPELLANT Lower Limits:1.8 Upper Limits:2.3 Extinguishing Media:CO*2,DRY CHEMICAL OR FOAM. Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA IN AN ENCLOSED AREA. Unusual Fire/Explosion Hazard:DO NOT SPRAY NEAR OPEN FLAME;KEEP AT ROOM TEMPERATURE AS EXPOSR. TO DIRECT SUNLIGHT MAY CAUSE BURSTG ================== Accidental Release Measures ================== Spill Release Procedures:USE PROPER PERSONAL PROTECTION:REMOVE ALL SOURCES OF IGNITION;VENTILATE;AVOID BREATHING VAPORS AND REMOVE WITH INERT ABSORBENT. ====================== Handling and Storage ====================== Handling and Storage Precautions:DO NOT STORE ABOVE 120F.KEEP AT ROOM TEMPERATURE AND AWAY FROM HEAT, OPEN FLAMES AND SUNLIGHT.DO NOT PUNCTURE/INCINERATE;DO NOT SPRAY NEAR FIRE/FLAMES Other Precautions:AVOID CONTACT WITH SKIN,EYES AND CLOTHES;DO NOT BREATHE VAPORS/MIST;KEEP AWAY FROM CHILDREN. ============= Exposure Controls/Personal Protection ============= Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATOR FOR ORGANIC VAPORS/MIST IF ABOVE PEL/TLV Ventilation:PROVIDE MECHAN(GEN/LOCAL EXHAUST)VENT TO MAINTN1.0 Evaporation Rate & Reference:>1.0 (ETHER=1) Appearance and Odor:AEROSOL:CONTENTS UNDER PRESSURE Percent Volatiles by Volume:10 ================= Stability and Reactivity Data ================= Stability Indicator/Materials to Avoid:YES NONE NOTED Stability Condition to Avoid:DO NOT STORE ABOVE 120F Hazardous Decomposition Products:CO ,CO*2 ==================== Disposal Considerations ==================== Waste Disposal Methods:DO NOT INCINERATE;DISPOSE OF IN ACCORDANCE WITH LOCAL,STATE AND FEDERAL REGULATION: Disclaimer (provided with this information by the compiling agencies): This information is formulated for use by elements of the Department of Defense. The United States of America in no manner whatsoever, expressly or implied, warrants this information to be accurate and disclaims all liability for its use. Any person utilizing this document should seek competent professional advice to verify and assume responsibility for the suitability of this information to their particular situation.